CONSTRUCTION CHECKLIST

When constructing, renovating, or adding to a firewise home, consider the following:

• Choose a firewise location.
• Design and build a firewise structure.
• Employ firewise landscaping and maintenance.

To select a firewise location, observe the following:

• Slope of terrain; be sure to build on the most level portion of the land, since fire spreads more rapidly on even minor slopes.
• Set your single-story structure at least 30 feet back from any ridge or cliff; increase distance if your home will be higher than one story.

In designing and building your firewise structure, remember that the primary goals are fuel and exposure reduction.  To this end:

• Use construction materials that are fire-resistant or non-combustible whenever possible.
• For roof construction consider using materials such as Class-A asphalt shingles, slate or clay tile, metal, cement and concrete products, or terra cotta tiles.
• Constructing a fire-resistant sub-roof can add protection as well.
• On exterior wall facing, fire resistive materials such as stucco or masonry are much better choices than vinyl which can soften and melt.
• Install non-flammable shutters on windows and skylights.
• To prevent sparks from entering your home through vents, cover exterior attic and underfloor vents with wire screening no larger than 1/8 of an inch mesh.  Make sure undereave and soffit vents are as close as possible to the roof line.  Box in eaves, but be sure to provide adequate ventilation to prevent condensation.
• Include a driveway that is wide enough to provide easy access for fire engines (12 feet wide with a vertical clearance of 15 feet and a slope that is less than 5 percent).  The driveway and access roads should be well-maintained, clearly marked, and include ample turnaround space near the house.  Also provide easy access to fire service water supplies, whenever possible.
• Provide at least two ground level doors for easy and safe exit and at least two means of escape (i.e., doors or windows) in each room so that everyone has a way out.
• Keep gutters, eaves, and roofs clear of leaves and other debris.
• Make periodic inspections of your home, looking for deterioration such as breaks and spaces between roof tiles, warping wood, or cracks and crevices in the structure.
• Periodically inspect your property, clearing dead wood and dense vegetation at distance of at least 30 feet from your house.  Move firewood away from the house or attachments like fences or decks.

Any structures attached to the house, such as decks, porches, fences, and outbuildings should be considered part of the house.  These structures can act as fuel bridges, particularly if constructed from flammable materials.  Therefore, consider the following:

• If you wish to attach an all-wood fence to your house, use masonry or metal as a protective barrier between the fence and the house.
• Use metal when constructing a trellis and cover it with high-moisture, low flammability vegetation.
• Prevent combustible materials and debris from accumulating beneath patio decks or elevated porches.  Screen or box-in areas below patios and decks with wire screen no larger than 1/8 inch mesh.
• Make sure an elevated wooden deck is not located at the top of a hill where it will be direct line of fire moving up slope.  Consider a terrace instead.

Access additional information on the Firewise home page: www.firewise.org.